The following scenarios describe the behavior of HMI for CNC device communications and CNC Alarm process with and without licensing:
If the base product, CIMPLICITY
HMI, is not licensed, HMI for CNC is also not licensed. CIMPLICITY
HMI will run in a two hour demonstration mode, however, the router
will shut down any HMI for CNC device communications and the HIM
for CNC Alarm process.
If the base product, CIMPLICITY
HMI, is licensed, but HMI for CNC is not licensed, HMI for CNC
device communications and the HMI for CNC Alarm process will shut
down immediately.
If the base product, CIMPLICITY
HMI, is licensed and HMI for CNC is also licensed, HMI for CNC will
run for the number of purchased licenses.
Other HMI for CNC applications will not perform any license checks and will perform normally regardless of CIMPLICITY HMI and HMI for CNC licensing. These other applications provide limited useful functionality that is not available from other sources. These applications include:
CNC Parts Program
(cnc_program).
Any program that uses cnc_dll.
For detailed information about licensing, refer to the Proficy Common Licensing help installed with your HMI/SCADA product.
|
|
Hardware and software requirements. |
