For

RCO

Project

Purpose

To set the RCO trigger functionality to what it was in CIMPLICITY versions that were lower than CIMPLICITY 6.2.

Comments

The initial point update in:

6.2 and higher

Is used to prime the initial value of TRANS-HIGH and TRANS-LOW points.

Less than 6.2

Is read and thrown away.

If a point is unavailable, then the initial point will not come until the point becomes available.

Therefore in:

6.2 and higher

RCO site will ignore the point values that are set before the RCO site started.

Less than 6.2

RCO does not ignore the first update; RCO uses the first unavailable to available point as a trigger.

Value

0

Ignore the initial point value before RCO started.

1

Do not ignore the initial point value before RCO started. (Use the less than 6.2 behavior).

Default Value

0

Global parameters.