Use the MODBUS RTU tab in the Device dialog box to enter information about Modbus RTU communications for the device. You can define the following:
|
RTU Address |
Enter the slave address of the device. For the Series Six, this is the CPU ID of the attached Series Six. Valid slave addresses range from 1 to 247 decimal. Broadcast mode (slave address 0) is not supported by the Modbus RTU device communications enabler. |
|
Enable |
Select YES to enable the device when the project starts. If you select NO, the device will not be enabled and points associated with the device will be unavailable. |
|
|
Modbus RTU device configuration. |
