Default Device Properties

Use the Default Properties tab to enter addressing information about this device.

Address

Enter the controller's address. The address is one of the following:

For target programmable controllers attached directly either point to point via RS-232 or on an RS-422 link, enter the programmable controller's Station Number

<station number>

where <station number> is in hexadecimal with a valid range of 0 to 1F.

Examples of local addresses are: 1A and 2

 

For programmable controllers on a MELSECNET or MELSECNET/B subnetwork to be accessed via a locally connected programmable controller, use the following format:

<station number>.<PC CPU number>

where <station number> is the station number of the programmable controller on the local serial network acting as the MELSECNET(/B) gateway and <PC CPU number> is the address assigned to the data link module attached to MELSECNET(/B).

 

Entries are in hexadecimal with a valid range of 0 to 1F for the station number and 0 to 40 for PC CPU number.

Examples of MELSECNET addresses are: 3.10, A.1A, and 0.1

CPU ID

Not used.

Enable

Select YES to enable the device when the project starts. Select NO to disable the device. If you select NO, the device will not be enabled and points associated with the device will be unavailable.

More information

Mitsubishi A-Series Serial device configuration.