Default Device Properties

Use the Default properties to enter addressing information about this device.


Enter one of the following:

For programmable controllers on a local Host Link, enter the programmable controllers Unit Address.

Sample local address: 10

For programmable controllers on a subnetwork, use the following format:

<CV bridge>.<subnetwork number>.<address>

Where <CV bridge> is the CV bridge on the local Host Link network, <subnetwork number> is the subnetwork number, and <address> is the Unit Address of the programmable controller.

Sample subnetwork address: 3.4.10


Note: Some C-Series PLC models cannot be accessed on a subnetwork via a CV Bridge. Please refer to the Supported OMRON Devices section for information on which C-Series models are supported via a CV Bridge.


Not used.


Select YES to enable the device when the project starts. If you select NO, the device will not be enabled and points associated with the device will be unavailable.

More information

OMRON Host Link device configuration.