On the Device tab in the Point Properties dialog box:
Update Criteria |
The update criteria determines how the data will be requested. |
|
Select On Change or On Scan for points whose values should be polled by the OMRON TCP/IP driver at regular intervals. |
|
Select On Demand On Scan or On Demand On Change for points whose values should be polled by the OMRON TCP/IP driver at regular intervals while users are viewing them. |
Address |
Point address requirements are device-dependent. Valid device types are: C-Series CS1- Series C-Series Point Addresses See the sections below for detailed information on the point address requirements for each device type. |
When you configure BOOL points from non-discrete memory (such as CIO, HR or DM) you must also enter data in the following field:
Bit Offset |
Enter the bit offset in the 16-bit memory word that defines the point where 0 is the least significant bit and 15 is the most significant bit. |
|
Warning: Do not enter a data Bit Offset for Point Type BOOL for Timer and Counter Completion Statuses or Temporary Relay (TR). Leave the field as the default 0. |
OMRON TCP/IP point configuration. |