You can create a Data Source point for each logical CIMPLICITY device. If configured, the point will be set to one of the following values:
Value |
Description |
0 |
No communication on any cable |
1 |
Current data is collected from the Primary PLC over the Primary Cable |
2 |
Current data is collected from the Primary PLC over the Secondary cable. |
3 |
Current data is collected from the Secondary PLC over the Primary Cable. |
4 |
Current data is collected from the Secondary PLC over the Secondary Cable. |
The addresses for the Status diagnostic point is:
$2,6 |
Data Source Point |