You can create a Status point for each cable connection. If configured, the point will be set to one of the following values:
Value |
Description |
0 |
OK-Indicates the enabler can connect to the PLC over this cable and the PLC has the expected state. |
1 |
NOT OK-Indicates there is a problem with either the cable connection or the state of the PLC. |
2 |
This cable is not configured. |
The addresses for the Status diagnostic points are:
$2,0 |
Status Point-Primary PLC over Primary Cable |
$2,1 |
Status Point-Primary PLC over Secondary Cable |
$2,2 |
Status Point-Secondary PLC over Primary Cable |
$2,3 |
Status Point-Secondary PLC over Secondary Cable |