When Point collection is designated in the Defect folder, the Point input fields display in the Defect Properties dialog box Collection tab.
To specify Point collection for
defect:
Select the Collection tab.
Identify the Point ID (data source) from which the SPC Data Collector retrieves data. The Point ID cannot have a Text type. Do one of the following:
Click 
to browse for an existing Point
in the Select a Point dialog box, or
Click 
to designate a New Point.
When using any array, specify the number where SPC should begin to collect values in the Start element field. Note that the default is 0.
When using any array, specify the number where SPC should finish collecting values in the End element field. Note that the default is 0.
Check the EU conversion box if the SPC Data Collector is to use the EU value(s) for the Point. Clear if the SPC Data Collector should use the raw value(s) for the Point.
|
|
Step 5.5. Define defect category collection properties. |
