Example 4.3.2. Enter Values for the Ratio Arrays

The factory's Tracker engineers:

  1. Stop the project; does a configuration update and re-starts the project.

  2. Open the Point Control Panel.

  3. Add the configuration array points for the Eliminate Sources Based on Rule function block.

  4. For each point:

  1. Double-click the point to open its Point Control Panel Point Properties dialog box.

  2. Enter a vae on the Detail tab.

Note: The entered value is actually the 0 element in the array.

Because there is only 1 element, the Array tab is not needed in the dialog box.

  1. Apply values to each parameter as follows

 

Parameter

Description

Point Array Values

 

 

Set Value

Element

 

1

Attribute Name

MONITOR

0

MON_NAME

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

2

Attribute Value

15

0

MON_VALUE

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

3

Block Size

5

0

MON_BLOCKSIZE

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

4

Block Limit

1

0

MON_LIMIT

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Result: The values (Element 0) display in the Point Control Panel list.

The configuration for Eliminate Source by Ratio evaluation is almost ready for runtime. RSA will enter the count values during runtime.

Note: The weight that will be assigned to failures still needs to be entered in the Set Block Weights function block.

Attribute Name

Attribute Value

BlocK Size

Block Limit

Attribute History

MONITOR

15

30

20

TBD

More information

Example 4.3. Define an Eliminate Source By Ratio evaluation.