You can create a Status point for each cable connection for a configured redundant PLC. If configured, the point will be set to one of the following values:
|
Value |
Description |
|
0 |
OK–Indicates the enabler can connect to the PLC over this cable and the PLC has the expected state. |
|
1 |
NOT OK–Indicates there is a problem with either the cable connection or the state of the PLC. |
|
2 |
This cable is not configured. |
The addresses for the Status diagnostic points are:
$CONN_STATUS_P1C1 Status Point–Primary PLC over Primary Cable
$CONN_STATUS_P1C2 Status Point–Primary PLC over Secondary Cable
$CONN_STATUS_P2C1 Status Point–Secondary PLC over Primary Cable
$CONN_STATUS_P2C2 Status Point–Secondary PLC over Secondary Cable
$CONN_STATUS_P3C1 Status Point–Third PLC over Primary Cable
$CONN_STATUS_P3C2 Status Point–Third PLC over Secondary Cable
|
|
Series 90 TCP/IP Triplex diagnostic points. |
