You can configure your reports to include
report legends. The information in the
report legend is derived from the information properties of the
underlying tag that is associated with a pen. If there are no
information properties defined for a tag, this information
isn't available for a legend.
You set up your report legends by using the Legend
panel of the Print dialog box.
To set up a report legend:
In the Print dialog box, click
the Legend tab. The Legend panel appears.
The panel shows, by default, the
Pen Options, Statistical
Analysis Options, and Cursors lists (if
there is a cursor currently displayed on the chart). The options
available to you might differ from the ones shown here.
Select the check box of the
Pen Options you want to include in your
report. For details about these options, see Configuring the Object
View.
Select the Statistical Analysis Options you want to include. This
section is available only if the chart contains at least one analog
or digital pen.
Minimum -
causes the minimum value from cache to be returned. Note that this
value might not be a real logged sample if the sample found is a
multiple calculated sample.
Maximum -
causes the maximum value from cache to be returned. Note that this
value might not be a real logged sample if the sample found is a
multiple calculated sample.
Average -
uses time-weighted averaging to determine the average for both
stepped and interpolated lines. This means that if a trend stays at
a value of 10 for 1 hour and then spikes quickly at a value of 50
for a minute, the average will not be significantly affected.
Select the Cursors you want to include.
If you want to include a report
legend, make sure the Include Legend check box
is selected.