Applies To:
  • CitectSCADA 5.41, 5.41 Service Pack A, 5.41 Service Pack B, 5.42, 5.42 Service Pack A, 5.50, 5.50 Service Pack A, 5.50 Service Pack B, 6.00
  • CitectHMI 5.41, 5.41 Service Pack A, 5.41 Service Pack B, 5.42, 5.42 Service Pack A, 5.50, 5.50 Service Pack A, 5.50 Service Pack B, 6.00
Summary:
What are the different settings I can use for each of my ABCLX devices?
 

Solution:
In addition to the general ABCLX section in the ini file (where parameters will effect all ABCLX devices on the system), it is possible to configure the following ini parameters on a per device basis (Please note: the values shown below are default values):

[<IOServer name>.<Port name>]
FailOnBadData=1
ForwardOpenPoolSize=4
InactiveScanAdjust=10
DirectReadRefresh=500
MissedPollTolerance=3
LogTagInfo=0
LogTagInfoPath="C:\"

For further information, please refer to the ABCLX help file Section "Advanced configuration and maintenance > Customizing a project using Citect.ini parameters" or contact Citect Support.
 
Keywords:
ABCLX, IO Device, configurable  

Attachments