Applies To:
  • CitectSCADA 7.0
Summary:

I created a new event called “My Event”, compiled the project (no errors or warnings were given), and then run Computer Setup Wizard and enabled “My Event”. When I run the project the event was not triggered. Going through the Set-up Wizard again, I can see that the event is not enabled (i.e. the tick I put before has gone).

 

Solution:

This is caused by the fact that there is a space in the event’s name. Rename “My Event” to, let’s say, “My_Event” to resolve the issue.

 
Keywords:
 

Attachments