The SNP Device Communication protocol supports disabling BREAK when using the Firmware version 8.2 of PLC Firmware on Series 90 devices.
The following project level global parameters have been added:
|
SNP_SEND_BREAK |
|
|
SNP_IDLE_TIME |
SNP_SEND_BREAK
|
For |
SNP Project |
|
|
Purpose |
To enable or disable sending BREAK. |
|
|
|
SNP_SEND_BREAK can be superceded on a port basis by defining <PORT>_SEND_BREAK. |
|
|
Value |
Choose one of the following. |
|
|
|
Y |
Enables BREAK. |
|
|
N |
Disables BREAK. |
|
Default Value |
Y |
|
SNP_IDLE_TIME
|
For |
SNP Project |
|
Purpose |
To set the number of seconds for idle time when BREAK is disabled. |
|
|
SNP_IDLE_TIME an be superceded on a port basis by defining <PORT>_IDLE_TIME. |
|
Value |
Number of seconds. |
|
Default Value |
10 seconds. |
|
|
About SNP and SNPX Communications. |
