SPC Parameters

The citect.ini file contains the following parameters:

• [SPC]AlarmBufferSize - Specifies the number of subgroups used in SPC Alarm calculations.
• [SPC]XFreak - The number of data points required to set the SPC XFreak type alarm
• [SPC]PartialSubgroup - Enables masking of subgroups from being included in calculations.
• [SPC]RAboveUCL - Sets the number of consecutive data points required to set the RAboveUCL SPC alarm.
• [SPC]RBelowLCL - Sets the number of consecutive data points required to set the RBelowLCL SPC alarm.
• [SPC]ROutsideCL - Sets the number of consecutive data points required to set the ROutsideCL SPC alarm.
• [SPC]XAboveUCL - Sets the number of consecutive data points required to set the XAboveUCL SPC alarm.
• [SPC]XBelowLCL - Sets the number of consecutive data points required to set the XBelowLCL SPC alarm.
• [SPC]XDownTrend - Sets the number of consecutive data points required to set the XDownTrend SPC alarm.
• [SPC]XErratic - Sets the number of consecutive data points required to set the XErratic SPC alarm.
• [SPC]XGradualDown - Sets the number of consecutive data points required to set the XGradualDown SPC alarm.
• [SPC]XGradualUp - Sets the number of consecutive data points required to set the XGradualUp SPC alarm.
• [SPC]XMixture - Sets the number of consecutive data points required to set the XMixture SPC alarm.
• [SPC]XOutsideCL - Sets the number of consecutive data points required to set the XOutsideCL SPC alarm.
• [SPC]XOutsideWL - Sets the number of consecutive data points required to set the XOutsideWL SPC alarm.
• [SPC]XStratification - Sets the number of consecutive data points required to set the XStratification SPC alarm.
• [SPC]XUptrend - Sets the number of consecutive data points required to set the XUptrend SPC alarm.

See Also