Driver commands

This function is used to influence a driver during online operation.

Give the driver and further options as the transfer parameters This function is configured via a dialog mask.

Configurable options are:

Select driver	all drivers loaded in the project
Actual command	displays current state
Driver Commands
– Driver start	driver is reinitialized and started
– Driver Stop	driver is stopped; no new data is accepted
– Driver in simulator mode Mode	Driver is set into simulation mode. The values of all variables of the driver are simulated by the driver. No values from the connected hardware (e.g. PLC, bus system, ...) are displayed.
– Driver in hardware mode	Driver si set to hardware mode For the variables of the driver the values from the connected hardware (e.g. PLC, bus system, ...) are displayed.
– Driver user commando	Driver specific user commands can be executed
– Driver Setpoint On	setting values on driver is allowed
– Driver Setpoint Off	setting values on driver is prohibited
– Driver modem connect	establish connection (for modem drivers)
– Driver modem disconnect	stop connection (for modem drivers)
Filter dialog	displays mask in online operation for manual actions