Client name

Manual -> Process Gateway -> Configuration Access IEC870SI -> Communication -> Logging -> Client name
Previous chapterNext chapter Show allShow all    Hide allHide all

The way the name of the client is displayed in the diagnosis viewer depends on the configuration. That is why the name changes if you change the TCP port, the COM port or the protocol. In this case, the logging settings may also change.

If the Process Gateway is started several times with the same settings, the same client name will be used. The error messages of the different instances can be distinguished by the process ID.

Example Example

zenProcGateway_IEC870Slave

  • 104 protocol with standard port 2404
  • 101 if COM1 selected.
  • If the configuration has not been loaded yet, error messages during startup wil always be visible under this client.

zenProcGateway_IEC870Slave:COM4

  • 101 with COM4.
    The name contains the used COM port.

zenProcGateway_IEC870Slave:Port:12345

104 with port 12345.
The name contains the port for the Master connection.