Error numbers

0000

No error

0101

Connection not established / configured

010a

Negative acknowledgement received / Timeout error

010c

Data does not exist or is locked

0200

Low resources in adapter.

0201

Wrong interface or MPI address specified

0202

Maximum number of interfaces exceeded

0204

Connections already established.

0206

Handle cannot be set

0207

Data segment cannot be locked

0209

Erroneous data field !

0302

Block too small, DW does not exist

0303

Block limit exceeded, correct number

0310

Assembly group not found

0311

Hardware error

0312

Configuration parameters incorrect

0313

Wrong Baud rate, wrong IntVector

0314

Wrong HSA

0315

MPI address error, double MPI address

0316

HW device already assigned

0317

Interrupt not available.

0318

Interrupt in use.

0319

SAP not in use.

031A

Connection error. No remote station found.

031B

Short circuit at Profibus. Syni Error.

031C

No bus profile found. System error

031D

Buffer size error.

0320

Hardware error

0330

Version conflict

0332

no response

0381

Device does not exist

0382

No driver or device found

0384

No driver or device found

03FF

System error

4001

Connection unknown

4002

Connection not established

4003

Connection is being established

4004

Connection failed

8001

Function not allowed for this operation status.

8100

Service of remote assembly group unknown.

8101

Hardware error

8103

Object access not allowed

8104

Context not supported

8105

invalid MPI address

8106

Type (data type) not supported

8107

Type (data type) not consisten

810A

Object does not exist

8301

Not enough memory on CPU

8404

serious error

8500

Wrong PDU size

8702

Address invalid

D201

Block name syntax error

D202

Function parameter syntax error

D203

Block type syntax error

D204

No embedded block available.

D205

Object already exists

D206

Object already exists

D207

Block exists in EPROM

D209

Block does not exist

D20E

No block exists

D210

Block number to high or invalid.

D241

Protection level of function not sufficient

D406

Information does not exist

EF01

Wrong ID2

FFCF

Invalid function parameters.

FFFE

unknown error FFFE hex

FFFF

Timeout error. Check interface

0800

Adapter cannot accept any new orders.

1001

Too many repetitions during reception or send request not received.

1004

No data or incomplete data received.

1005

Amount of received data does not match the expected length.

1006

Too many repetitions during sending.

1007

Interface cannot be opened Maybe specified wrong COM or COM already in use.

1008

Could not change Baud rate of the adapter communication. Maybe Baud rate invalid for this adapter model.

1009

Control system data type not supported by driver.

100A

Target address not configured. Correct the configuration.

100B

Clear to send request (STX) not received.