Driver commands

Previous chapterNext chapter Show allShow all    Hide allHide all

This function is used to influence a driver during online operation.

Give the driver and further options as the transfer parameters This function is configured via a dialog mask.

Configurable options are:

Select driver

all drivers loaded in the project

Actual command

displays current state

Driver Commands

Driver start

driver is reinitialized and started

Driver Stop

driver is stopped; no new data is accepted

Driver in simulator mode Mode

Driver is set into simulation mode.
The values of all variables of the driver are simulated by the driver. No values from the connected hardware (e.g. PLC, bus system, ...) are displayed.

Driver in hardware mode

Driver si set to hardware mode
For the variables of the driver the values from the connected hardware (e.g. PLC, bus system, ...) are displayed.

Driver user commando

Driver specific user commands can be executed

Driver Setpoint On

setting values on driver is allowed

Driver Setpoint Off

setting values on driver is prohibited

Driver modem connect

establish connection (for modem drivers)

Driver modem disconnect

stop connection (for modem drivers)

Filter dialog

displays mask in online operation for manual actions