Mouse |
|
Manual -> Runtime -> Operating during Runtime -> Mouse |
   Show
all  Hide
all |
A single click with the left mouse button an a dynamic element opens (depending on the setting of the dynamic element) the standard dialogbox for setpoint input. Depending on the data type of the variable the following dialogboxes are opened:
Possible operations are:
|
Command |
|
|---|---|
|
Switch to spontaneous value |
Display spontaneous value (value from PLC), if substitute value was displayed before |
|
Modify spontaneous
value |
Write new spontaneous value to the PLC |
|
Switch to mode spontaneous value |
Combination of the two commands above |
|
Switch to alternate value |
Display substitute value (value from variable definition), if spontaneous value was displayed before |
|
Modify alternate value |
Set new substitute value for variable |
|
Switch to mode substitute value |
Combination of the two commands above |
|
Switch off spontaneous value |
Switch off connection to PLC |
|
Switch on spontaneous value |
Switch on connection to PLC |
|
Presetting of set status |
- LOW (0) |
Possible operations are:
|
Command |
|
|---|---|
|
Switch to spontaneous value |
Display spontaneous value (value from PLC), if substitute value was displayed before |
|
Modify spontaneous
value |
Write new spontaneous value to the PLC |
|
Switch to mode spontaneous value |
Combination of the two commands above |
|
Switch to alternate value |
Display substitute value (value from variable definition), if spontaneous value was displayed before |
|
Modify alternate value |
Set new substitute value for variable |
|
Switch to mode substitute value |
Combination of the two commands above |
|
Switch off spontaneous value |
Switch off connection to PLC |
|
Switch on spontaneous value |
Switch on connection to PLC |
|
Value |
New numerical value (within defined measuring range) |
Possible operations are:
|
Command |
|
|---|---|
|
Switch to spontaneous value |
Display spontaneous value (value from PLC), if substitute value was displayed before |
|
Modify spontaneous
value |
Write new spontaneous value to the PLC |
|
Switch to mode spontaneous value |
Combination of the two commands above |
|
Switch to alternate value |
Display substitute value (value from variable definition), if spontaneous value was displayed before |
|
Modify alternate value |
Set new substitute value for variable |
|
Switch to mode substitute value |
Combination of the two commands above |
|
Switch off spontaneous value |
Switch off connection to PLC |
|
Switch on spontaneous value |
Switch on connection to PLC |
|
Text |
New text |
