The Series 90 TCP/IP Triplex communications enabler supports standard (non redundant) and both cabling and PLC redundancy for Series 90 TCP/IP communications.
Standard configuration allows CIMPLICITY to
communicate with a Series 90 or VersaMax interface through a single
Ethernet connection.
PLC
redundancy describes the ability to configure a group
of PLCs to act as a single logical data source.
Cabling redundancy describes the ability to
configure two network paths to the same PLC.
This communication interface supports communication to the GE Fanuc Series 90 and VersaMax products, which have an installed/configured Ethernet Interface.
For redundant communication, the enabler supports the standard GE Fanuc Series 90-70 hot-standby, synchronized CPU and GMR system products, Trimations HBR-30, HBR-70, and TMR-30 products and custom redundancy applications based on GE Fanuc Series 90 PLC in single and cable redundant applications.
This enabler supports the following CIMPLICITY features:
Polled reads at user defined
rates
Poll after setpoint
Triggered reads
Unsolicited data
Analog deadband
Alarm on communications
failure
Server Redundancy
configurations
This enabler supports the following data types:
Signed 8, 16, and 32 bit
integers
Unsigned 8, 16, and 32 bit
integers
Floating point
Text
Arrays
|
|
Series 90 TCP/IP standard configurations. |
|
|
Series 90 TCP/IP Triplex supported devices. |
|
|
Series 90 TCP/IP Triplex supported memory types. |
|
|
Series 90 TCP/IP Triplex hardware configuration requirements. |
|
|
Series 90 TCP/IP redundancy. |
|
|
Series 90 TCP/IP Triplex redundancy failure conditions and action. |
|
|
Series 90 fault table. |
|
|
CIMPLICITY configuration for Series 90 TCP/IP Triplex. |
|
|
Series 90 TCP/IP Triplex diagnostic points. |
|
|
Series 90 TCP/IP Triplex unsolicited data support. |
|
|
Series 90 TCP/IP Triplex advanced configuration topics. |
|
|
Series 90 TCP/IP Triplex enabler used with server redundancy. |
|
|
Series 90 TCP/IP Triplex global parameters. |
